Home
Jets
Introduction
Jet Pump General Info
Introduction to Jet Versatility
Principle of Operation
Model Selection Guide
Pumping Liquids with Liquid
Pumping Liquids with Steam
Pumping Gases with Steam/Gas
Pumping Gases with Liquid
Heating Liquids In-Tank
Heating Liquids In-Line
Mixing Liquids
Transporting Solids
Problems/Solutions Using Jets
Eductor Application Form
OnLine JetSizing Application
Gages & Gagecocks
Introduction
Armored Flat Glass Gages
Glass Information
Low/Medium/High Pressure Flat Glass Gages
Large Chamber, Weld Pad & Ultra High Flat Glass Gages
Steam/Water Flat Glass Gages
Offshore Gage Glasses
Gagecocks
Series 100, 200, 300 & 400
Series 500, 700, 550, 750 & 600
Tubular Glass Gages
Series N2, K2, K3 & N6 & N7
Magnetic Liquid Level Gages
Introduction
Magnetic Gage General Info
Follower/Flag Style Indicators
Point Level Control Measurement
Continuous Level Measurement
Top Mount & Mini
Options & Accessories
Magnetic Gage Application Form
Sight Flow Indicators & Sight Windows
Introduction
ANSI
Dual-Window
Lined
Full-View
Threaded Window Indicators
Angled
Threaded Sight Windows
Indicator and Window Accessories
Boiler Trim Products
Introduction
Penberthy Series 1AElectronic LevelIndication
Penberthy Series 2AElectronic LevelIndication
Penberthy Series 4AElectronic LevelIndication
Penberthy Series12A Electronic LevelIndication
Penberthy Series12B Electronic LevelIndication
Penberthy SeriesWater Columns
Steam/Water FlatGlass Gages
Literature
Contact Us/
Locate Distributor

News
FAQ
Distributor Login
Pentair


Search

Pentair
121 W. 1st St
Suite 200
Geneseo, IL 61254
PH: 309-946-5205
FAX: 309-946-5206 eMail: Click Here

 

Penberthy Series 1A Electronic Level Indication

 

The Penberthy Series 1A single probe alarm system represents the latest advancement in electronic level indication. Based on the conductivity probe technology now widely accepted in the industry, it was specially designed to meet increasing demand for a reliable, cost effective means of sensing water in various applications. The probe can be mounted directly to the pressure vessel or column. The probes are welded stainless steel HP and IP electrode with zirconia insulator (3000 psig @ saturation, up to 1200°F [207 barg @ saturation, up to 649°C]) or threaded stainless steel LP electrode with Teflon® insulator (850 psig @ 525°F [58 barg @ 274°C]). The Series 1A is a direct replacement for mechanical float switches. Local LED indication of water level provides either redundant or primary visual verification.

Teflon® is a registered trademark of E.I. du Pont de Nemours & Company

Typical Applications

  • Water Intrusion Protection for Turbines
  • Sump Pump Protection
  • Boiler Drum Level
  • Equipment Drains (Desuperheaters, Control Valves, Sootblower Systems)
  • Receiver Tanks (Condenser, Water Tank, Deaerator)
  • Flash Tanks, Feedwater Heaters
  • Steam Line Drain Pots
  • High Pressure Systems (where float switches are economically not acceptable)

Specifications

  • Single level switch applications
  • Single probe, single output relay module
  • Low voltage sine wave used for water detection (<17 Vac RMS nominal)
  • Net integral zero current waveform. No DC = no possibility of electrolysis of water or plating
  • Local LED indication of relay state
  • Available with water column or custom piping stub, fitting, spool piece, sight flow indicator (within temperature limits) or available with fittings for welding, threading to existing piping
  • Enclosure: Potted octal relay case
  • Maximum sensitivity:
    • 10 microsiemens/0.1 megohms - cm water
  • Input Voltage:
    • 24 Vac nominal, 50-60 Hz
    • Unit incorporates MOV protection
  • Relay contact:
    • Form C, SPDT
    • 5A @ 120 Vac
    • 5A @ 30 Vac
  • Operating Temperature:
    • 0 - 160° F
    • [-17°C/+71°C]

Standard Assembly

  • Electronic Module
  • Probe
  • Probe Cover
  • 36" [910 mm] of HT wire
  • 20" [500 mm] Conduit
  • Type "A" or 1 1/2" [40 mm] Male SW connector

Optional

  • 1 1/2" [40 mm] Connector welded in 1 1/2" [40 mm] Tee Class 3000 ANSI Class 3000
  • 120/240 Vac to 24 Vac transformer and electronics in Type 4X enclosure
  • Custom fitting with electrode holder

 

    © 2013 Pentair Ltd. All Rights Reserved